Today, the film blower manufacturer brings you the matters that you need to pay attention to when operating a professional film blower:
First of all, the important point is that when operating the machine, the operator cannot stand in front of the machine to prevent the machine from accidents and cause damage to the operator. When feeding The hard object of the machine is adjusted into the barrel. When operating the rotating machine, it is forbidden to bring gloves to prevent being injured by the machine.
Secondly, check and add the lubrication oil in the reducer and air pressure machine before operation, and check the lubrication of the mechanical rotation component to avoid the parts too dry and cause the damage machine and send noise. There are disconnection, leakage, or whether the instrument is damaged. Before the operation, the safety of each component should be guaranteed to avoid production accidents.
Furthermore, within the range of film formation, to increase the temperature, the temperature of the cooling air, and bloating ratio of the formation, and when the membrane is buckled uniform, you need to wear a glove to slowly lift the pipeline blank, and at the same time closed the port to close the port. , Slightly turn on the intake air conditioning valve, put the center rod center hole in a small amount of compressed air, and then carefully lead the foam rack, human font board, and put into the traction roller, guide roller until the rolling, blew the compression of the tube blank compression of the tube blank compression of the billet The air pressure should be appropriate. It must not cause the tube to break, but also ensure the symmetry and stability of the membrane tube, which relatively guarantees the production of quality.
Finally, after the operation is completed, when the extruder and the module need to be cleaned up, you can use copper knife, stick or compressed air to clean up. But do not damage the surface of the screw and screw to keep the surface smooth.
