1. Preparation
Before installing the double-sided blade for film blowing machine, you need to do the following preparations:
1. Turn off the power of the film blowing machine and unplug it to ensure safety.
2. Prepare the required installation tools and spare blades.
2. Remove the original blade
1. First, find the blade, which is usually located inside the winding assembly.
2. Use a wrench to easily loosen the screws to loosen the original blade base.
3. Gently remove the original blade base and place it next to the installed spare blade.
3. Install the new blade
1. Install the spare blade on the original blade base and fix the blade base with screws. Be careful to tighten the screws to ensure that the blade base is safe and firm.
2. Gently put the installed base back to its original position, push it tight and fix the base with screws. If necessary, check again whether the screws are tight.
3. Make sure there is no gap between the bottom of the blade and other parts to ensure the safety of the blade.
4. Test the newly installed blade
Add film material and turn the film blowing machine to normal operating speed to test whether the newly installed blade is working properly. If any abnormality is found, the machine should be stopped and checked in time.
5. Pay attention to safety matters
1. When removing and installing the blade, you must pay attention to safety. Turn off the power of the film blowing machine and unplug it.
2. During operation, pay attention to the safety of your fingers and other parts of the body, and do not put your fingers too close to the blade.
3. After the operation is completed, remove the surrounding tools and debris to avoid affecting the normal operation of the film blowing machine.
[Conclusion]
