When the film blowing machine, the plastic particles can be heated and discharged at the time of operation, and then it is made into a thin film. Because the variety of plastics is very rich and the use of plastic film is also wide, how do we adjust the accuracy of the model of the membrane machine in use?
Precise adjustment device of the mold header header. This unit uses the advanced spiral mold head structure. According to the particularity of high -voltage, low -voltage, mixture, and regenerative polyethylene materials, comprehensive consideration The main technical parameters such as length and the opening degree of the mold port have been selected and fixed after multiple comparison tests, including cores with spiral channels, feed inlets, mold barrels, inner mouth molds, mold circles and outlets. In the middle of the product's mold circle, there is an inner mold, and the product is equipped with an outlet between the inner mouth of the product and the mold ring.
There is a feed inlet above the mold bucket of the mold header, and below the product of the product is equipped with the inner spiral core with a spiral channel, the middle spiral core and the outer spiral core are the inlet Connect, the product reduction connector is located below the spiral core. There are coarse -tuning circles at the exit of the inner, middle, and outer spiral cores of the product. There is a regulatory bolt around the each of the products of the product. According to the accurate adjustment of the model header header, it will definitely bring positive effects to the majority of plastic film production industry.







